SOB...One of my threads caught an an error last night two hours after I started it. I then upped the voltage again this morning at 8am, started again, when back to sleep. It caught an error just one hour into it. Is it just coicidence that even though I'm upping voltages a little bit, it sometimes can't last as long under stress? Or should I disregard this because my vcore is still considerably low?
note: Although my stupid "dominator" ram is dominating at a low 800mhz still, I did tighten the timings from 5-5-5-15 to 4-4-4-12 recently. Can this increase the likelihood of failing stress tests? But heck, its certified to run 4-4-4-12 at 800 out of the box, surely this isn't an issue...
when i wnated to oc from 3.3 to 3.43(my max) i had to looses timings to 5 5 5 15.
try that and see what happens.
and what do you have your voltage at right now?make sure it doesnt go too high.