Rate the Wire Management Above You!
- Thread starter phucng_10
- Start date
Apokalipse
Golden Master
- Messages
- 14,559
- Location
- Melbourne, Australia
I'd guess is either powder coating, or it's been anodized
Ethereal_Dragon
Fully Optimized
- Messages
- 3,755
- Location
- USA
Ok, still in ROUGH draft form.......
Ethereal_Dragon
Fully Optimized
- Messages
- 3,755
- Location
- USA
Just the IDE drive is facing the wrong way.... it is history once I get Windows loaded onto one of the 500 Gig drives though, so it is short-term. As far as the TRUE, I haven't yet checked temps on it, need to get the software, not sure what to go with. Speedfan is all I have used previously. Other thing I need to do is extend the front panel connectors so I can route them behind the motherboard.
NosBoost300
I poop on the rug
- Messages
- 10,220
- Location
- Bellflower, CA
a bit messy above me.. but ther armor or anything in the same body frame is a bit hard to work w/
Dell Boi
Baseband Member
- Messages
- 68
- Location
- Newcastle, England
Not the best, granted.
Merkwürdigeliebe
Benevolent Cake Despot
- Messages
- 1,733
- Location
- Montreal, CANADA
aspire
The Water Cooling Guru
- Messages
- 5,308
- Location
- United States
@ Higach
I think I just threw up a little in my mouth...
@ Dell Boi
Bah it's a Dell...
@ Etheral Dragon
I noticed you picked up the same paint I used in my Aurora. I found that the finish really hardened up after a couple of days. The first couple days it was very soft and prone to scratching.
I love how yours turned out. Still not a big fan of the case but w/e.
I think I just threw up a little in my mouth...
@ Dell Boi
Bah it's a Dell...
@ Etheral Dragon
I noticed you picked up the same paint I used in my Aurora. I found that the finish really hardened up after a couple of days. The first couple days it was very soft and prone to scratching.
I love how yours turned out. Still not a big fan of the case but w/e.
Similar threads
