Command Rate?

Status
Not open for further replies.

Poemaster

In Runtime
Messages
284
Hey was doing some overclocking (love my Ballistix) and I noticed an option to change command Rate between T1 and T2 what is this what does it do etc. I am running at T2 atm apparently?
 
it will affect it A LOT. most ddr2 that is spec'd at 2t will not run 1T over its stock speed. ie if you have ddr2-800 spec'd at 2T, it will likely not run 1T at any frequency higher than 400mhz. even close to that is a challenge most of the time. for it to make a difference, you need to keep the other timings as tight as possible.
like, if you go to CAS 6 with 1T, you might as well stay at CAS 4 with 2T.
 
Dont even bother with DDR2, i have seen 1 in a 100000 actually work, and its never ever stable. DDR3 though is a different story so if you wait a while you can try that :)
 
Status
Not open for further replies.
Back
Top Bottom