natedogg42
Baseband Member
- Messages
- 26
Hey guys, i am having a problem with an old case..... the two wires for "Power LED" are attached at the end with a 3 pin connector piece if that makes any sense...therefor despite it being only 2 wires, it will not fit over the two pins that it needs two...lemme try to draw a graphic...
X
X
X <----wires twisted around one another
X
X
/ \
|ooo| <----connecter, with middle whole left without wire
_|_|_ <---two pins that it needs to fit onto
I hope that crappy graphic helps explain the problem....
Is there a way to take off that 3 wire connector thing and replace it with two? or just to take out one of the wires and move it to the middle so I can plug it into the mobo leaving a little piece of the plastic hanging off the side???
what kind of place would have the little connector piece that I need?? thanks
---uber n00b
X
X
X <----wires twisted around one another
X
X
/ \
|ooo| <----connecter, with middle whole left without wire
_|_|_ <---two pins that it needs to fit onto
I hope that crappy graphic helps explain the problem....
Is there a way to take off that 3 wire connector thing and replace it with two? or just to take out one of the wires and move it to the middle so I can plug it into the mobo leaving a little piece of the plastic hanging off the side???
what kind of place would have the little connector piece that I need?? thanks
---uber n00b