Q6600 OC ? How to make it more stable?

[PRVRT]

I have my quad OC @ 3.25. Runs everything I do stable, no problems with games(Crysis) or surfing. I just started folding, and hmmmm, BSOD after about 12 hours. Question is, how do I find out what needs to be changed on the OC'ing in order to make it run more stable?

I am not looking for Orthos this, Prime that, agrument to start either.

 

[Ste]

Screw slow increments.
Speed: 400X9
Vcore: 1.35
RAM Voltage: + .2
Northbridge voltage + .1
FSb voltage: + .1
RAm timming: 5-5-5-15
RAM Ratio: 1 to 1.

 

[PRVRT]

Ok, got it running at 3.0GHz atm. Tried 400x9, did not want to go. Problem is so many options to set on this board. Have it at:

CPU V 1.35
Ram Timing 5-5-5-15
Mem @ 800
Other settings are the problem. Everything is in auto. When I go to change it, I have no idea where to start as nothing on all the voltage options is selected. When I choose lower voltages, it shows green, middle voltages show yellow, and top voltages show red which would correspond to my Voltage LEDS on the board. So basically I need exact voltage (1.10V) settings that I should start with, cuz +.1V does not give me a starting point, or should I start with the lowest possible voltage and try each one 1 at a time?
Also with the CPU V @ 1.35v, AI Suite shows 1.2880 V and flucuates a little bit. Is that an acceptable voltage drop? Temps are solid at 55C right now folding.

 

[Ste]

Either list the options word for word or take a picture.

 

[PRVRT]

Here are some pics:

On this last pic I selected the NB voltage and this is the option I get.

 

[Ste]

Find out what the defualt voltages for the following.
South and north bridge voltage.
DRAM Voltage
FSB termination voltage

Post them when u do.
basically, One notch up for each I listed, and a Vcore of 1.30 for 3.2 Ghz.

 

[PRVRT]

That is my problem, I have not figured that out. I tried CPU-z, but it does not show those, only CPU V 1.280 and JEDEC#1 and 2 show 1.8V, EPP #1 2.1V. Any other way to find this out?

 

[Ste]

Software is unreliable for voltage readings, Check on manufacture site or in manual.

 

[PRVRT]

OK, will look in manual. I did just find PC Probe will show these.

Component Nominal Current

V Core 1.30v 1.28V
SB 1.09V 1.06V
NB 1.30V 1.36v
DRAM 1.89v 1.98v
FSB 1.24v 1.34v
Dram Ref 1.30v 1.36v

 

[Ste]

Like I said, you cannot trust software voltage readings.