All right guys first off i have a cheap 2.8ghz celeron (yea, celeron it was hella cheap so be quiet) and ive been stepping it up to 3.31ghz which i think is pretty good. The problem is i dont know if the temps i have for it are good for an overclocked machine or not so ill post them.
Clock Speed Idle Temp Load Temp
2.8ghz - 2.94ghz - 3.08ghz - 3.22ghz - 3.31ghz
33C - 33C - 33C - 33C - 33C
48C - 49-50C - 50C - 51-52C - 53C
So idle stayed around 33C and load went from 48C to 53C which i think are pretty good but if i go over 3.31ghz the system gets a bit unstable (the load program i used, Prime 95, started reading errors) so my question is this are these temps good and if they are should i try and go higher by upping the voltage to stabilize it and going further?
Clock Speed Idle Temp Load Temp
2.8ghz - 2.94ghz - 3.08ghz - 3.22ghz - 3.31ghz
33C - 33C - 33C - 33C - 33C
48C - 49-50C - 50C - 51-52C - 53C
So idle stayed around 33C and load went from 48C to 53C which i think are pretty good but if i go over 3.31ghz the system gets a bit unstable (the load program i used, Prime 95, started reading errors) so my question is this are these temps good and if they are should i try and go higher by upping the voltage to stabilize it and going further?