mike4realz
In Runtime
- Messages
- 404
i was bored so i decided to overclock my rig. i can't get my e6600 @ 2.4ghz to overclock to at least 3ghz. i can only get it to 2.9ghz (i can only set the FSB up to 325mhz, anything higher than that, my comp would freeze). here's how i set it up the voltage:
cpu -1.4125v
fsb -1.5v
mem -from 1.8v to 2.0v
north bridge -1.35v
south bridge -1.5v
VTT -4%
- memory timing: lowered the latency to 4-4-4-10
- disabled the following in the BIOS (c1e, eist, dot, all spread spectrum, execute disable bit, CPUID limit, HPET)
- my rig is at the bottom and it's watercooled
- used orthos for stressing with no errors (temp under 45C load and 30C idle)
cpu -1.4125v
fsb -1.5v
mem -from 1.8v to 2.0v
north bridge -1.35v
south bridge -1.5v
VTT -4%
- memory timing: lowered the latency to 4-4-4-10
- disabled the following in the BIOS (c1e, eist, dot, all spread spectrum, execute disable bit, CPUID limit, HPET)
- my rig is at the bottom and it's watercooled
- used orthos for stressing with no errors (temp under 45C load and 30C idle)