Tried 3.3GHz and got blue screen!

[pinoy3000]

Hm.... I tried jumping from 333MHz FSB to 366MHz FSB at 1.35 Volts with 9 Multiplier and for some reason I got the blue screen.

I set the RAM at the same timing at 5-5-5-15 but at 930MHz from 1000MHz.

If I want to go up higher in FSB how do I know what is the right frequency for the RAM and the timing? Do I increase the frequency also or decrease it? How about the timing?

I thought if you increase the FSB, you need to decrease the RAM frequency too. Hm.... Or did I just not decrease it low enough? Or should I change the timing too? to what? 4-4-4-12 or 6-6-6-18? Dont know what to do.......... Want to get this thing to 3.3GHz but I get the blue screen which is a RAM issue.

 

[san21893]

Don't take such a huge jump, bring it up by 5-10 fsb at a time. Especially since you're pretty far over stock speed. Btw, 1337 voltage in your sig, was that on purpose?

 

[phucng_10]

That's unstable. From 333MHz, increase it to 344MHz. Do by increments.

 

[b1gapl]

You need more juice, to the CPU.