Ok my comp is all finished on the hardware side of things...only problem i have atm is that i have an IDE HD and IDE CD drive so i need to run them on the same cable...i have set the jumpers each possible way like the HD=master and CD=slave, i have also switched them around and to no avail i have even switched the cable a couple times...when i go to the bios setup thing it is blank next to the IDE channel master drive but it actually says none next to the slave drive...i got it to read the cd one time but not the hard drive so i dont know what to do next the cd drive is still good and the hd is a brand new 80gb WD HD (getting a new HD soon)