Gigabyte P-35 DS3R mounting problems

Status
Not open for further replies.
hm my case had 9 stand off screws.

you should have some little red washer looking things. use that and the screws. just try different ones till you find the one with the right threads.
 
No, the motherboard itself is insulated at the screw points. My ds3r mounted just fine.

what screws did you use to mount the ds3r mobo? All my case came with are 3 kinds of screws, one kind is too small in diameter and the mobo will rock around, the other is too short to properly fit deep enough into the golden case pegs/mounts, the last kind is slightly longer the bottom side of the head is like rough and ends up cutting some dust off the mobo when I try to tighten it ( top view of this screw looks like this: Image:Cross slot screw.jpg - Wikipedia, the free encyclopedia )

My case also uses these screws to bolt the back plates and stuff...so yeah Im completely stumped...the horrid case and mobo instructions dont even mention what screws to use
 
Status
Not open for further replies.
Back
Top Bottom