Stock overclocking with the E6600

Status
Not open for further replies.

Raknor

In Runtime
Messages
142
While i'm probably going to get an aftermarket cooler eventually i'd like to see how far i can push it on stock. idle i get 36c full load (ie cnc tiberium wars) 50c
im using core temp. is there a guide to stock overclocking? should i even attempt ocing with these temps, if so how high would you reccomend?
 
While i'm probably going to get an aftermarket cooler eventually i'd like to see how far i can push it on stock. idle i get 36c full load (ie cnc tiberium wars) 50c
im using core temp. is there a guide to stock overclocking? should i even attempt ocing with these temps, if so how high would you reccomend?

http://www.techist.com/forums/f10/b1-my-computer-blew-up-what-do-i-do-145944/

I'm at 3.4. Temps are rather high but then again it's been very hot here in bakersfield ca.
 
C&C3 is nowhere near full load. Try three instances of Prime95 (blend/small FFT/large FFT) and look at your temps.
 
yeah google orthos and download that....CNC barely uses my CPU at all....it doesn't even really stress my GPU as it has a max fps of 30
 
Status
Not open for further replies.
Back
Top Bottom