Help me reach 3.4ghz or higher with E6300!

Status
Not open for further replies.

j12

Daemon Poster
Messages
1,133
My E6300 is at 3.12ghz and I want to reach 3.4ghz. I am using a zalman cnps 9700. The cpu is at 38 degrees centigrade. I am using a gigabyte ds3 motherboard. To overclock my cpu i have not increased any voltages, only increased the fsb. I also want to overclock my ram a little bit. My timings according to cpuz are.

Frequency: 450mhz
FSB DRAM: 1:1
CAS#Latency: 5.0
RAS# to CAS# Delay: 7
RAS# Precharge: 7
Cycle time (Tras): 19
Bank cycle timer (trc): n/a
Command rate:2T
DSCF0329.jpg

DSCF0328.jpg
 
Agreed with zmatt. You're going to have to juice it up a little, to get it to 3.4GHz. And what RAM are you using? Those timings are very loose.
 
Allright the timings are now 5-5-5-15. But I had the lower the Fsb a little. What should i do next.
Core speed: 3.115
multiplier x7
Bus speed 445.0 mhz
 
Have you tried going to 3.2? If it's stable at 3.1, go to 3.2....then stress test it. If it's not stable, up the VCore voltage one notch. Then stress it again. If it's still not stable up the VCore another notch....etc. If it's at 3.2, and you stress it, and it's stable, proceed to 3.3...
 
Status
Not open for further replies.
Back
Top Bottom