Need help. I finally got it!

[andrewsvalesen]

well its "cured" for 5 weeks so far. I'm going to try to:
Increase the FSB by 10mhz in my CPU, and give it a shot. Then I'll check temps.
I'll continue to bring it up, until I crash, then I'll raise the voltage by .1, and my memory by .1

Is this a good strategy?

 

[b1gapl]

Yes...that's what overclockers, usually do. But that temp is too high. It would be better, to have it under 60C.

 

[andrewsvalesen]

interesting..

 

[andrewsvalesen]

I just read that my memory clock limit is DDR 400, but thats actually DDR 800, because ram is doubled, right?

My "CPU" Frequency is 200
and my PCIE clock is 100mhz.

which one is my fsb or my multiplier?

my volts:
Mem volt: 1.96
Chipset 1.55
HT volt: 1.2

 

[b1gapl]

Yes, ram speed is doubled.

The CPU frequency would be the FSB.

 

[andrewsvalesen]

i learned quite a bunch in like 5 minutes, i found where you can lower timings to the ram

*note, i fixed the RAM issue.

Should I lower the timings? or anything with the ram?

 

[b1gapl]

Don't touch the ram yet. Worry about, getting higher FSB speeds, first. So currently, your CPU freq. is at 200MHz right? So set it to 210, and then stress it, with either prime 95, orthos, or stresscpu2...overnight.

Also, don't touch the PCIe clock. It's best to leave that alone.

 

[andrewsvalesen]

alrighty. And if it reaches 60 celsius i should stop?
Man... i have no idea why the temps are so high!

 

[b1gapl]

What are the other temps? Such as the hard drives, motherboard, graphic card, etc...

 

[andrewsvalesen]

i will list them... hold up