ScoobieSnacks
Beta member
- Messages
- 5
Hello knowledgeable people.
I recently purchased a dvd burner, the I/O Magic IDVD16DLS, and swapped it out with my cd burner. The ide (secondary) cable is connected to my CD-ROM (slave) and my DVD burner (primary). My other ide (primary) cable is connected to a single hdd. When I started my computer with my new burner the computer would not boot. I only get the "no signal" on my monitor. However, when I unplug the power going to either my cd-rom OR my dvd burner, then the computer will start as normal. I thought that I needed a new psu so I bought a 500W psu to replace the 300W psu. Nothing changed.
I recently purchased a dvd burner, the I/O Magic IDVD16DLS, and swapped it out with my cd burner. The ide (secondary) cable is connected to my CD-ROM (slave) and my DVD burner (primary). My other ide (primary) cable is connected to a single hdd. When I started my computer with my new burner the computer would not boot. I only get the "no signal" on my monitor. However, when I unplug the power going to either my cd-rom OR my dvd burner, then the computer will start as normal. I thought that I needed a new psu so I bought a 500W psu to replace the 300W psu. Nothing changed.