Shorcut not working? Tried sys restore

Status
Not open for further replies.

brrymnvette

In Runtime
Messages
225
I have a program that won't open after the computer has been on for a day or so. I have to restart the comp before it will work again. No matter how I try to start it, it won't come up. I tried sys restore but it's a relatively new comp and the restor only went back a week. Ran a virus scan on it also. What can I do now?


Thanks,
Andy
 
OptiPlex GX520 Small Form Factor,Celeron D 326 / 2.53GHz256K,533FSB
NTFS File System
512MB,Non-ECC,400MHz DDR2 2x256
Dell UltraSharp 1704FPT Flat Panel with Height Adjustable Stand,17.0 Inch VIS,
80GB SATA, 7200 RPM,Hard Drivewith Data Burst Cache
3.5 inch, 1.44MB, Slimline Floppy Drive
Windows XP Professional Service Pack 2
24X CDRW/DVD Combo
Integrated AC97 Audio,OptiPlex


They are hooked up all day. USB connection. I have 2 other of the exact same comps running w/o problems.
 
have you tried other USB ports?

if all the comps are the same without installing any other software then it must be hardware related.

check all usb ports could also try updating the drivers for that motherboard.

also look in the event viewer for any problems go to start>run and type eventvwr. Check applications for any conflicts and system.

also look in device manager for anything suspicious mainly looking for yellow ! marks. Hold the windows key and press pause break then go to hardware then device manager.
 
Status
Not open for further replies.
Back
Top Bottom