reggie_da_man
Fully Optimized
- Messages
- 2,679
So I recived my Leadtek 7900GS a few days ago stock at 450/1320. I overclocked without voltmodding at first and got to 537/1550 which i wasn't too happy about for the core. Now I'm pumping 1.55V through my card and have the resistor shaded for my ram. My core maxes out at around 650 and the ram is 1764. I find this a little depressing since I've seen these cards hit upwards of 700Mhz on the core. I've got the Zalman vf-700 installed with OCZ BGA ramsinks. Full load temps hit 78*C with 1.55V. I'm thinking of either getting a tidewater or getting a new pump and putting an extra loop in and getting a water block for my GPU. Any other idea's on getting my core higher?
With that being said one thing I'm not too sure of is I tried to unlock the last four pipelines but I'm not sure if i did it successfully.
See I can't hit apply so is it good?
Also how's this for a 3D 05 mark?
With that being said one thing I'm not too sure of is I tried to unlock the last four pipelines but I'm not sure if i did it successfully.
See I can't hit apply so is it good?
Also how's this for a 3D 05 mark?